QuickJack 3500SLX, Setup And Operation Manual

Page: 7 / 144

QuickJack™ Portable Car Jack
7
P/N 5900263 — Rev. B6 —September 2023
• While handling a Hydraulic Cylinder or a Hydraulic Hose, also wear gloves. In rare cases, a needle-
like stream of hydraulic fluid (even at low pressure) can penetrate fingers, hands, or arms; such a
puncture can feel like a bite, electric shock, or a prick. While it may seem like a minor issue, any
amount of Hydraulic Fluid injected into the human body is a serious issue. Anyone suffering such a
puncture wound should be immediately taken to a hospital emergency room to determine the
extent of the injury. Explain the circumstances of the injury to the attending physician, including
what kind of Hydraulic Fluid was involved. Do not assume a puncture wound that could have been
caused by Hydraulic Fluid is a minor issue; it could be life threatening.
• Floor surface must be dry, flat, and have a minimum compressive strength of 500 PSI. The Lift
must not sink into the ground or crack the surface under the weight of the Vehicle.
• Avoid using an extension cord; they can overheat. If you must use an extension cord, make sure it
is No. 14 AWG / 2.5mm
2
minimum.
• Exercise caution in locating the electrical cable and Hydraulic Hoses; do not drive over or step on.
• Clear the area if a Vehicle is in danger of falling off the jack.
•
Make sure both Lock Bars are engaged before nearing an elevated Vehicle.
•
As an added precaution, you must
always
use auxiliary safety stands under the Vehicle while
elevated on both QuickJack Frames.
Symbols
Following are the symbols used in this manual:
⚠
DANGER Calls attention to an immediate hazard that
will
result in death or severe injury.
⚠
WARNING Calls attention to a hazard or unsafe practice that
could
result in death or severe
personal injury.
⚠
CAUTION
Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
Tip Calls attention to information that can help you use your QuickJack better.
Liability Information
BendPak assumes no liability for damages resulting from:
• Use of the equipment for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak.
• Injury or death caused by modifying, disabling, overriding, or removing safety features.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.