QuickJack 3500SLX, Setup And Operation Manual

Page: 48 / 144

QuickJack™ Portable Car Jack
48
P/N 5900263 — Rev. B6 —September 2023
Maintenance
Refer to ANSI/ALI ALIS Standard (current edition)
Safety Requirements for Installation and Service of
Automotive Lifts for more information about safely servicing your QuickJack.
⚠
DANGER
Before performing any maintenance to your QuickJack, verify it is completely
disconnected from power. If your organization has Lockout/Tagout policies, make
sure to implement those procedures after connecting to the power source.
Replace labels and worn, damaged, or broken parts from
quickjack.com/replacement-parts
.
Only use factory-supplied parts as replacement parts. All maintenance tasks can be performed by the
owner/operator of the QuickJack.
To maintain your QuickJack
:
• Daily . Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before equipment is put back into operation.
• Daily . Keep all QuickJack components clean.
• Daily . Make sure the Safety Locks are in good operating condition. Do not use your QuickJack if
the Safety Locks are damaged or excessively worn .
• Daily . Inspect Lift Blocks for damage or excessive wear. Replace as required.
• Daily . Inspect Quick-Connect Fittings. See Quick-Connect Fittings Maintenance and Best
Practices below.
• Weekly . Check all hose and fitting connections to make sure they are tight.
• Monthly . Lubricate all hinge points and check for excessive wear.
• Monthly . Cycle the Frames up and down several times with weight at least once a month. This
will help maintain the cylinder seals’ elasticity.
•
Every other month
. Check Hydraulic Fluid levels and refill if required.
• When required . Replace all caution, warning, and safety-related labels if illegible or missing.
Lubrication Points
QuickJack recommends using white lithium grease (or equivalent) and a grease gun with an
appropriate tip (a Lube-Link™ or similar) for lubrication. Apply to both Frames, lubrication points are
indicated below.