Width Adjustment of the footrests
If the footrest width needs to be adjusted, please undo the screw (1),
set the desired width, by positioning 1, 2 or 3 spacers (2) from outer
to the inner side and then refit the screws, (Fig. 6.3.6).
Lightweight footrest
The footrest angle can be adjusted by loosening the screws (2). Side
protection panels can be fitted to the footrest using the mounting
holes (3). These prevent the feet slipping off accidentally, (Fig. 6.3.7).
Make sure that after any adjustment work, all screws are tightened
correctly (see the page on torque).
Width adjustment
To adjust the width of the footrest please open the screw (2). Then
you can slide in and out the tubes in the holder to adjust the width of
the footboard (Fig. 6.3.7).
Please make sure that the screws are tightened with the correct
torque.
High-mount footrest
(Fig.6.3.8 - Fig.6.3.9)
The footplates can be flipped up to facilitate getting in and out of your
wheelchair.
The footplates can be adjusted within their angle of inclination,
relative to a level surface. Loosen the screws (1 to 2). Then set the
footplates to the desired angle. Afterwards, tighten all screws. After
adjustment, always make sure that all screws are tightened properly
(see the page on Torque). In order to avoid the wheelchair tipping
over, make sure that the minimum interval of 2.5 cm between the foot
rest tubing and the ground is maintained (with horizontal seat).
Elevating legrest - standard
To flip up:
Pull the footrest upwards and adjust to the desired height. When
doing this, the footrest clicks audibly into place (Fig. 6.3.10).
To lower:
Briefly take the load off the footrest by lifting the lower leg and then
push the release lever.
In this way you can swing the footrest downwards. As soon as you let
go of the lever, the footrest will click back into place.
WARNING!
•
There is a risk of trapping fingers when moving the footrest up or
down.
•
Do not put your fingers in the adjusting mechanism between the
frame and the moving parts of the footrest.
•
The footrests are not designed to be used to lift or carry the
wheelchairs with an occupant.
•
When getting into or out of the chair, never stand on
the footboards.
Fig. 6.3.6
1
2
Fig. 6.3.10
Fig. 6.3.7
2
2
3
3
Fig. 6.3.8
1
2
Fig. 6.3.9
3
4
22
ENGLISH
Rev.1.0
NEON 2 SA
Summary of Contents for Neon 2
Page 7: ...M5 5 0 Nm M6 7 0 Nm M8 10 0 Nm Nm 7 Nm 5 Nm 7 Nm 7Nm 2Nm 5 Nm 5 Nm 25 Nm 1 5 Nm 7 Nm 7 Nm...
Page 98: ......
Page 99: ......
