Quickie Neon 2, Instructions For Use Manual

Page: 21 / 100

WARNING!
The footrests are not designed to be used to lift or carry the wheelchairs
with an occupant.
Hanger play adjustment
In case of play the hanger (Fig. 6.3.2) can be adjusted in the field. The
hanger pin (1) is tapered and the play can be reduced when the pin is
unscrewed slightly.
Take the hanger off the chair in using the release mechanism.
Use an screw driver and turn the pin (1) in the front carefully to the left. Then
test the hanger on the chair. If the hanger mechanism is not working/catching
anymore, please undo the task slightly.
If the play is still too large and the performance not accepted, please repeat
the task.
Lower leg lengths
By undoing the clamp screw, 2 (Fig. 6.3.3), you can adjust the lower leg
length. Loosen the clamp screw, adjust the tube with the footboard to the
desired position.
Tighten clamp screws again (see the page on torque). Ensure that the plastic
push joint is located under the clamp screw in the correct position.
WARNING!
• Do not stand on the footplate during transfer. The chair is likely to tip to
the front when standing on the footplate. Always place your feet securely
on the ground for transfering into or out of the chair.
Platform Footplates
The footboard can be flipped up to make it easier to transfer to and from the
chair.
The footboard can also be tilted to six different angles relative to a level
surface.
Tighten screw (1) firmly on the outer side.
By removing the clips (2) the footplate can be adjusted to three different
positions toward both the front and rear. Loosen the adjustment screw (3) to
change the horizontal position of the footplate. For this purpose, the footplate
must be flipped up, (Fig. 6.3.4 to Fig.6.3.5).
When finished, make sure that all screws have been properly tightened (see
the page on torque).
A minimum interval of 2.5 centimetres from the ground should always be
maintained.
Fig. 6.3.3
Fig. 6.3.4
Fig. 6.3.5
Fig. 6.3.2
21
ENGLISH
Rev.1.0
NEON 2 SA