52
HULA
Rev.1.0
With the seating in an elevated position, drive the
•
wheelchair to make sure that the ‘creep’ mode works
which will slow the wheelchair.
Drive the wheelchair in each of the drive profiles to
•
make sure the wheelchair performs as it did before.
CAUTION!
If you are in any doubt about the performance
•
requirements of your wheelchair contact your Sunrise
Medical authorised dealer.
You should check the items on this chart at the
•
indicated intervals. If any of the items are loose, worn,
bent or distorted, immediately have them checked
and/or repaired by your authorised Sunrise supplier.
Frequent maintenance and servicing will improve
•
performance, extend wheelchair life, and help prevent
injuries.
12.13 Performance checks
After performing any maintenance or repairs on the
wheelchair you must make sure that it is functioning
correctly before it is used.
Visually inspect the wheelchair to make sure the
•
legrests, armrests etc are correctly positioned and
attached to the wheelchair and all fasteners are
sufficiently tightened.
Make sure that the backrest is correctly fitted and
•
adjusted.
Make sure that all of the cushions are in place
•
Switch on the hand control – Do the lights flash? This
•
signifies that there is a fault in the electronic system.
Refer to section 8 for basic troubleshooting.
Perform the parking brake check.
•
Operate all of the electric options, including lights
•
and indicators (if fitted) to make sure that they work
correctly.
Maintenance & Inspection Schedule
Daily
*
W
eekly
Quarterly
Annually
Check battery level indicator and charge if necessary
¯
Check the joystick of the hand control is not bent or damaged
¯
Ensure all parts and assemblies are securely fastened
¯
Checkanterior pelvic support for wear and make sure the buckle is
operational
¯
Motor Brake Test
¯
Check tyre condition and wheel fasteners.
¯
Ensure lights and indicators, (where fitted), are operational and
clean
¯
Ensure all cables and connectors are sound and are tidy and out of
the way
¯
Check upholstery, seating, headrests, arm pads and calf pads for
wear.
¯
Inspect all nuts, bolts, studs and fasteners for damage and tightness.
Contact your authorised dealer for service assistance.
¯
Clean wheelchair upholstery
¯
Check battery terminals for tightness etc.
¯
Complete inspection, safety check and service should be made
by a Sunrise Medical authorised dealer
¯
Fig.12.18
Daily = Before each use of the wheelchair.
*