HULA
15
Rev.1.0
4.24 Anterior Pelvic Support
The Anterior Pelvic Support kit. (Fig. 4.7).
Fastening the anterior pelvic support:
Insert the 3 prong male buckle into the female buckle until
a click is heard
(Fig. 4.8)
To fit the anterior pelvic support.
Place the strap loosely across the seat with the buckle
•
closed.. (Fig. 4.9)
Pass the other ends of the strap through the gap
•
between the backrest posts and the backrest
upholstery as shown. (Fig. 4.10)
Ensure that the adjusters & buckles can be accessed
•
& the strap is not twisted. Fit the eyelets over the
rearmost bolts. Fit the plain washer, sprung washer &
nut. Tighten with a 13.0mm spanner. (Fig. 4.11)
Ensure that the anterior pelvic support is tight enough
•
to provide comfortable support. A simple measure
is to keep a hands thickness between the body
andanterior pelvic support. For safety, check the
tension on the anterior pelvic support at least once
day. (Fig. 4.12)
Generally, the Anterior Pelvic Support should be fixed
•
so that the straps sit at an angle of approximately 45°
(Fig. 4.13), and when correctly adjusted should not
allow the user to slip down in the seat.
WARNING!
Ensure that the Anterior Pelvic Support is secured
•
and correctly adjusted before use.
An incorrectly fitted/adjusted Anterior Pelvic Support
•
could allow the user to slip down, potentially causing
serious injury.
Inspect the Anterior Pelvic Support at regular intervals
•
for any signs of fray or damage and replace as
necessary.
When servicing, check for correct operation of the
•
release buckle and for any signs of wear on the
material or plastic brackets.
Fig. 4.8
Fig. 4.9
Fig. 4.10
Fig. 4.11
Fig. 4.12
Fig. 4.13
Fig. 4.7
