17
EN
TCD 1062 - REV002A
OPERATION
TCD 1062 DISABLING (THRUSTER COMMAND)
The remote control is disabled in the following cases:
• When the enabling button is pressed.
• When there are several remote controls in parallel and another is activated.
• Once 6 minutes elapse from the enablement and not any other operation is performed or from the last time the joy-
stick is moved.
• When the mushroom push-button switch is pressed.
(In this condition, the enabling Leds will flash slowly and the joystick will be disabled, while the Power OFF Leds re-
main on).
Passage to the disabled state is signalled from the control with a prolonged sound of around one second and the fol-
lowing slow flashing of the enablement leds. The TCD1062 is disabled.
MULTIPLE REMOTE CONTROLS IN PARALLEL
Several TCD series remote controls can be installed in parallel. In this case, only one remote control can function at a
time. The active remote control is always the last one to be activated; the other in parallel are automatically disabled.
When a thruster is commanded by the last remote control enabled, the boat movement direction will be indicated by
the relative LED which will light up also on the other disabled remote controls.
MAIN SWITCH COMMAND FUNCTIONING
As soon as the main switch command is powered, the Power ON and Power OFF LEDs will switch on for two seconds.
Afterwards, if the mushroom push-button is not pressed, the Power ON LED will start flashing slowly indicating that the
system is on hold, whereas the Power OFF LED will be off.
If a thruster command connected to the system is enabled, the Power ON LED will switch on steady, showing that the
thruster command and TMS main switch command are enabled.
In case the mushroom push-button is pressed, the Power OFF LED will switch on and the TCD controls present and the
TMS will be disabled (Power ON LED off).
In order to release the mushroom push-button, the red knot must be turned clockwise.
Disablement/enablement of the sound of the control
The acoustic signals emitted by the control can be disabled.
Carry out the following procedure:
• Remove power to the control.
• Keep the enablement key pressed and supply power to the control which will emit a short sound.
• Release the enablement key and wait for the control to perform the testing of the LEDs and for it to be disabled (slow
flashing of the enablement LEDs).
The acoustic signals emitted by the control can be re-enabled.
Carry out the following procedure:
• Remove power to the control.
• Keep the enablement key pressed and supply power to the control which will emit two short sounds.
• Release the enablement key and wait for the control to perform the testing of the LEDs and for it to be disabled (slow
flashing of the enablement LEDs).