MANUAL DE USUARIO
12
1)
The orientation of the cell housing must
always be vertical. Note that the tab marked
in the following picture is facing away from
the wall, i.e. towards you. The control unit
will be embedded on this side, assuming you
choose mounting type A (cell and control unit
in one block).
2)
On the inside of the housing, you will notice
that there are two baffles marked IN and OUT.
These deflectors can be interchanged with
each other.
Choose the correct position according to your
hydraulic system, so that water enters the cell
through the deflector marked “IN” and exits
through the one marked “OUT”.
Note:
The arrow in the picture above indicates the correct direction of
the water flow.
Once the accessories have been glued, the cell can be assembled. Please follow the steps below:
2.3.2. Assembly of the cell
3)
Place the cell beaker in its location, making
sure that the joints of both ends are correctly
placed in their housing.
4)
Place the locking hooks between the
fittings and the cell inlet/outlet. Tighten them
with an Allen key to ensure watertightness.
Locking hook
