Super Automatic
8
8
11. TAKING OUT OF SERVICE
11.1. Temporarily
Run a cleaning cycle for the coffee group
Carry out the daily maintenance procedures.
Turn off the main switch, disconnect the power plug.
Empty the water tank, the drip tray and the dregs
drawer and wash them.
Store the machine in a dry place protected from the
elements and with limited access (avoid leaving it
within reach of children).
11.2. Permanently
If the machine is to be put out of order or scrapped, the
following steps should also be taken in addition to the
procedures for taking out of service temporarily:
Cut the power cord.
Pack the machine in cardboard or similar and consign
it to the relevant authorized recycling or recovery
service.
12. TROUBLESHOOTING GUIDE
In the event of damage to the power cord,
contact an authorized service center to have it
replaced as this requires special equipment.
If waste materials from maintenance are polluting or
non-biodegradable, they should be placed in separate
containers and consigned to the appropriate collection
centres.
Checks that can be carried out by the user.
A) The machine does not switch on:
-
Check that the plug has been connected.
-
Check that there is electric current and that the circuit
breaker or main switch is on.
-
Check the condition of the plug and the power cord;
if they are damaged have them replaced by a
qualified electrician.
-
Check the fuses in the machine socket (Figure 2-13).
B) Does not dispense coffee:
-
Lack of water in the tank; top off the level and then
turn the machine off and on again.
-
Coffee pump overheated, wait for the thermal
protector to reset.
-
Grind is too fine, adjust coarser. (Figure 4)
C) Does not dispense hot water or steam:
-
The machine has not reached operating temperature.
-
The water level in the boiler has not been topped up;
switch machine off and on again.
-
Nozzles blocked; clean the nozzles on the steam
wand spray.
E) Not dispensing coffee properly:
-
Coffee ground too fine or too coarse.
-
Ensure there is coffee in the coffee hopper.
F) Does not grind coffee:
-
Check the protection fuse on the inside of the door, if
it is blown replace with one of the same type, press
and turn counter-clockwise (Figure 7).
G) Cappuccino frother not working:
-
Clean frother parts shown in figure 6
For any other kind of anomaly or problem not
specified here, unplug the machine from the
power supply, do not attempt any repairs or
inspections and contact an authorized service center.
FIGURE 7
