Rev 1. 1 05/08/19
- 1 -
TELSEC
©
MP2 User Guide
1
Overview
The TELSEC
®
MP2 is designed to provide advanced monitoring and alarming for remote facilities and
cabinets using industry standard communications protocols such as SNMP, DNP3 and SMTP (Email) over
Ethernet. The system has a built-in web server for status review and programming and can be polled
using SNMP GET requests. The MP2 has up to 32 universal inputs for monitoring temperature, humidity,
contact closures and any 0-6 VDC or 0-20 mA sensors. Each individual input may be scaled and
displayed in the proper engineering units. The system has two RS485 serial port for monitoring Modbus
RTU devices or to act as a DNP3 Outstation and four digital outputs which can be actuated based upon
user programmable events. This user guide is intended to provide basic operational information for
programming and status review of the MP2 System. Please contact Quest for additional information
and or questions about the operation of the system.
1.1
Getting Started
The TELSEC
®
MP2 is simple to setup and program which allows you to start monitoring your facility
quickly. The basic steps are listed below along with a chapter reference for this manual:
1.
Mount the MP2 in the desired location (section 3.1)
2.
Power the system. (section 3.2.1)
3.
Connect the inputs to be monitored to the system. (section 3.4)
4.
Connect one or both serial ports to Modbus RTU Devices. (section 3.5)
5.
Wire the digital outputs. (section 3.8)
6.
Connect the MP2 to an Ethernet switch and configure the IP settings. (section 5.1)
7.
Configure the system (Section 8.1)
8.
Configure the alarm distribution. (section 8.2)
9.
Define the inputs. (section 9.1)
10.
Define the Modbus points. (section 9.3)
11.
Define the alarm points. (section 9.4.1)
