Rev 1. 1 05/08/19
- 14 -
TELSEC
©
MP2 User Guide
Figure 14 - Modus Input Status
Modbus points that are writable, will be displayed with a write icon
. Clicking on this icon will bring
up a window to allow the user to change the value. Enter the value in the converted engineering units
that are being displayed. The MP2 will use the point definition to determine the correct value to be sent
to the device. Note: the actual ability to change a value is dependent on the device being monitored.
Even though the MP2 attempts to write the data, the device may reject the change.
6.3
Output Status
The output status page shows the current status of the four digital outputs. Each output will be shown
with the defined name, Action which is either automatic (AUTO) or BYPASSED if a user has bypassed the
output (Settings/Bypass). The state field shows whether the point is Active or Inactive based upon the
user defined program. The last function is the ability to Acknowledge the current active state which will
cause the output to go to an inactive state until the next condition causing an Active state occurs.
Figure 15 - Digital Output Status
