11
7.1 Setting Up a Wireless Alarm Network
Creating an interconnected wireless alarm network is a simple process, with intelligent “self-enrollment” features, and
user-friendly voice prompts.
A.
remoVe All deVIces From theIr PAcKAgIng
b.
PoWer UP All deVIces
•
Locate the red wheel on the back of the device. Turn the red wheel to
the “ON” position on ALL devices using the white tool included with the
Quick Start Guide.
•
Once powered, the light rings will glow red and voice message will announce, “Ready to connect. Follow Quick
Start instructions.”
note:
If no further steps are taken within 15 minutes of initial power up, a voice prompt, “No devices found, not
connected” will be heard once, and the wireless function will turn off. The unit will then perform as a standard stand
alone alarm. See Section 7.3 for re-activating wireless.
c. PIcK one deVIce
Press and hold the button on only ONE device until you hear two beeps.
Release button. You will hear “Searching for other devices”.
•
The light will pulse and device will sound a continuous “Sonar” ping until
step E is complete.
d.
relAX And WAIt
Wait until all devices have connected to network. Once connected, each
device will speak, “Success now connected!”
•
Once connected, the lights will glow green.
e.
PIcK one deVI ce
Press and hold the button on only ONE device until you hear 2 beeps.
Release button. “Sonar” ping will stop.
•
Device will announce that setup is complete and the number of con-
nected devices.
Figure 7.1-B
ON
ACTIVATION
TOOL
Figure 7.1-C
DON'T press buttons
on other devices
“Searching for
other devices.”
Hold for
5 seconds
Figure 7.1-D
“Success, now
connected!”
Figure 7.1-E
Hold for
5 seconds
