Wi-Fi&Bluetooth Module Series
FC80A_Hardware_Design 44 / 43
8
Compliance Information
OEM/Integrators Installation Manual
Important Notice to OEM integrators
1.This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part
2.1091(b).
3.The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4.For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to
verify compliance as a composite system. When testing the host device for compliance with Part
15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B
while the transmitter module(s) are installed and operating. The modules should be transmitting
and the evaluation should confirm that the module's intentional emissions are compliant (i.e.
fundamental and out of band emissions). The host manufacturer must verify that there are no
additional unintentional emissions other than what is permitted in Part 15 Subpart B or emissions
are complaint with the transmitter(s) rule(s). The Grantee will provide guidance to the host
manufacturer for Part 15 B requirements if needed.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
Declaration of Conformity
Hereby, [Quectel Wireless Solutions Co., Ltd] declares that the radio equipment type [
Wi-Fi & BT Module
]
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
RF exposure statement
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based
on a distance of d=20 cm between the device and the human body. To maintain compliance with RF
exposure requirement, use product that maintain a 20cm distance between the device and human body.
