Page 8 of 16
2.6
Servicing and Maintenance
I30 SERIES is not serviceable nor does it require regular maintenance or calibration. If
experience any difficulties with our product please refer to the Troubleshooting section of
this manual or contact Quickte customer service.
2.7
Laser Safety
This product complies with IEC60825-1:1993 + A2:2001 and IEC 60825-2, 3
rd
Edition,
2004-06.
INVISIBLE LASER RADIATION
DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
2.8
Precautions
General Precautions
WARNING:
Do not install the equipment in an environment where the operating
ambient temperature might exceed 60
0
C or below -10
0
C.
WARNING:
Make sure the air flow around the front, sides, and back of the
device is not restricted.
WARNING:
Never leave tools inside the chassis.
Lifting Precautions
WARNING:
Make sure the rack or cabinet housing the equipment is adequately secured
to prevent it from becoming unstable or falling over.
WARNING:
Mount the equipment you install in a rack or cabinet as low as possible,
placing the heaviest device at the bottom and progressively placing lighter devices above.
Power Precautions
WARNING:
Use BOTH power supply, and provide separated branch circuits for the
power (48V DC). This provides redundancy in case one of the circuits fails.
WARNING:
To completely remove power, disconnect all power supplies.
WARNING:
Disconnect the power supply from the outlet before pulling or plugging
power supply card
WARNING:
Always connect the ground wire
WARNING:
Ensure that the equipment does not overload the power circuits, wiring, and
over-current protection. To determine the possibility of overloading the supply circuits,
add the ampere (amp) ratings of all devices installed on the same circuit as the device.
