Page 12 of 16
2.9.6
Attaching a PC or Terminal
These ports are used for management:
RJ45:
To connect with PC through RJ45 by using IP address to telnet in or by using
Web GUI.
RS232:
To connect with PC through RS232 port by using Virtual Terminal
There are a number of sessions you can open for different user interfaces:
Web GUI: you can access equipment by using Microsoft Internet Explorer. Please
use windows IE 6.0 or higher version.
•
CLI: there is no pre-set limit on the number of sessions. It is however equipment
memory limited. Up to 5 sessions running simultaneously has been tested and
found to work properly. But if a large number of sessions are running on the
equipment simultaneously, the response may be slower. Note that you can run
only one session per login and all login name/password are the same for this
version.
•
SNMP: SNMP is a UDP protocol, which is "connectionless". Thus it doesn't have
session limitation
To attach a management station using the RJ45 port:
z
The fastest way to connect to PC is to use Web GUI through RJ45 port. You need
a RJ45 cable to connect with your PC and switch. Then run IE to access
equipment.
z
I30 SERIES equipment needs an IP address for its proper management. The
default IP settings are as following:
IP Address 192.168.0.1
IP Mask 255.255.255.0
IP Broadcast Address 0.0.0.0
IP Default Gateway 192.168.1.254
I30 SERIES default login name is ALWAYS
admin
, default is no password.
Quickte highly recommend that you change the password when you first use yourI30
SERIES equipment.
NOTE:
Changing the IP address will cause you loss the connection to the chassis
;
you
need to restart a new telnet session with the newly assigned IP address and reconnect
.
The IP address will not change if you restart the system or restore the factory default
settings.
