Page 10 of 16
2.9
Preparing the Installation Site
2.9.1
Cabling Infrastructure
Ensure that the proper cabling is installed in the site. DC power wires should be able to
support the maximum current draw. Communications cabling, serial or Ethernet should
be installed and working.
2.9.2
Installation Location
Before installing the equipment, plan its location and orientation relative to other devices
and equipment. Allow at least 3 inches of space at the front of the device for the twisted-
pair, fiber-optic, and power cabling. Also, allow a minimum of 3 inches of space between
the sides and the back of the device and walls or other obstructions.
2.9.3
Rack Mount Installation
•
Remove the rack mount kit from the shipping carton.
•
Attach the mounting brackets to the sides of the device as illustrated below.
•
Attach the system to the rack as illustrated below.
Go to "Powering On a System”.
•
Step 1 step 2
Figure: Installing a chassis device in a rack mount
2.9.4
Desktop Installation
•
Set the equipment on a flat desktop, table, or shelf. Make sure that adequate
ventilation is provided for the system - a 3-inch clearance is recommended on
each side.
•
2.9.5
Installing a DC Power Supply
•
Prepare the negative and return wires by stripping about 1/4" of insulation off
