Introduction
Options
Ball Return Installation Manual
– 612-860-010
1
Rev. Date 10/07
HOW TO USE THIS MANUAL
This manual contains information needed to properly install, operate, and maintain the
Options Ball Return. If any terms, concepts, or operations contained in this manual are
not clear to you, consult an experienced professional or QubicaAMF Technical Support.
INTRODUCTION
Before you begin the installation, check your shipment against the packing list to ensure
that all parts have been included. Report missing items to QubicaAMF at 1-866-460-
7263 between the hours of 8:00 a.m. and 5:00 p.m. Eastern Time. After 5:00 p.m., you
can leave a message on the voice mail system. The 24-hour fax line is 1-804-559-8650.
Address all faxes to QubicaAMF Technical Support.
When you see this symbol associated with an
instruction,
a possible hazard is indicated.
Follow these
instructions carefully.
Before installing, removing, or replacing electronic
equipment, be certain that the supply power to the
unit has been turned OFF at the main circuit
breaker box.
Verify that the power source matches that required
by your Ball Return. The load rating is 10 amps for
115-volt units and 5 amps for 220-volt units. The
circuit breaker should be sized according to
applicable local and regional codes.
Protect the approach and lane surfaces before you
begin installation of the Ball Return unit.
Before applying power to a Ball Return, be sure that all cables have been
connected properly — especially the main power cables.
Before operating a Ball Return, be sure that all GUARDS are in place.
WARNING!
Read This
BEFORE
Proceeding.
TO AVOID INJURY:
Read these safety
precautions before
attempting to install
or modify any AMF
equipment.
Failure to follow
these procedures
may result in
severe personal
injury, fire, or
permanent damage
to property.
!
!
