EazyRizer Assembly Instructions (09/01)
Page - 4-
lower rear slider guide mounting holes are elongated for ease of
alignment.
Step 12:
You might need a helping hand for this next part. While putting adequate pressure (kneeling) on the lifting arm
(furthest away from slider guides), move the lower rear slider guide so that it touches pillar firmly. Tighten the
Nylock nut to 18 foot/pounds of torque. Next tighten the upper front rolling pin guide in the same manner while
still maintaining weight on the lifting arm. Now, tighten the remaining two rolling pin assemblies to 18
foot/pounds.
Step: 13
Next, you will need to insert the screw thread shaft into
the top pillar flange hole.
Please note the picture to the right for the proper component order.
Top washer (if provided), raceway washer, ball bearing assembly,
raceway washer and finally the white nylon bushing. Please note that
this bushing sits on top of the vertical pillar hole.
After you insert the screw thread shaft and before inserting it into the
bronze lifting assembly, you will need to slip on the “large” rubber
bushing . Raise this bushing to the top of the screw thread shaft.
Step 14:
Carefully line up the screw shaft with the threaded bronze lifting
assembly and screw the shaft clockwise all the way until the bottom of
