EazyRizer Assembly Instructions (09/01)
Page - 3-
bottom 17 mm bolts to 24 foot/pounds of torque.
Step 8:
Next, you will need to remove the two rear most “slider” guides from
the lifting arm assembly. You will need two 13 mm wrenches to
accomplish this task.Remember the order and position of all
components and lay them aside in a safe place for now.
Step 9:
Prior to mounting the lifting arm onto the vertical pillar, you must insert
the (8) black nylon guide buttons into the appropriate holes in the
lifting guide assembly. As shown here, we suggest that you use a
small dab of petroleum jelly or silicone to help hold each button in
place while assembling
Step 10:
IMPORTANT: Please note the head position of the (8) black nylon
guide buttons. The large head MUST face to the inside of the lifting
guide assembly as shown. At this point you can carefully slip the
lifting guide assembly around the vertical pillar. Make sure that you
don’t push out any of the nylon guide buttons while doing so. Re-
attach the rearmost slider guides and bolts. Tighten the Nylock nuts
two or three turns only.
Step 11:
To aide in alignment while tightening the lifting arm assembly onto the
vertical pillar, place a small wood block (1x3; 2x4, etc.) as shown. You will see that the upward forward and
