ble IdeaShare acts as a whiteboard recorder; recording data as it is written on the
whiteboard and displaying that data in the eBeam Software application window.
Software Installation & First Time Use
This chapter describes how to set up and use eBeam Software.
1.
Set up Quartet Portable IdeaShare as described in the Quick Set Up Guide that is
included with Quartet Portable IdeaShare.
2.
Insert the software CD into the CD-ROM drive on your computer. The installer
(Macintosh or PC) will start up automatically. If the installer does not start up
automatically, browse to your CD-ROM drive and select the setup program. Follow
all on-screen directions.
3.
Launch eBeam Software. The first time eBeam Software opens, it opens in
Whiteboard mode (see “Terminology” on page 9). You are prompted to calibrate
Whiteboard mode immediately.
If you do not wish to use Whiteboard mode, skip this step.
If you do wish to use Whiteboard mode, click Calibrate to open the Whiteboard cal
ibration wizard and follow all on-screen instructions. See “Calibrate Whiteboard
Mode” on page 12 for a description of how to manually start calibration for White
board mode.
Note:
If eBeam Software was unable to autodetect Quartet Portable IdeaShare,
see “Troubleshooting” on page 22.
4.
Select the mode you wish to use. The three possible modes (described in
“Terminology” on page 9) are:
•
Whiteboard mode
•
Flip Chart mode
•
Projection mode
Note
: In the PC version of eBeam Software, the first time you launch eBeam Soft
ware, eBeam Software opens a mode selection dialog. Select “Capture from
Whiteboard” (Whiteboard mode), “Capture from Flipchart” (Flip Chart mode), or
“Use with Projector” (Projection mode), and click the Calibrate button. eBeam
Software opens the appropriate calibration wizard.
Page 10
Using eBeam Software with Quartet Portable IdeaShare
https://www.supplychimp.com
