Quantum ValueLoader DLT VS160, User Manual

Page: 53 / 88

ValueLoader Administration
Running the ValueLoader System Test
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 39
Running the ValueLoader System Test
3
The System Test option cycles the ValueLoader through the process of
loading, calibrating, and unloading all cartridges in the carousel.
Running a System Test verifies the operational soundness of both the
ValueLoader and tape drive. The System Test continues indefinitely until
you press the
[Cancel]
button. All regular backup and restore operations
are suspended while a System Test is in progress.
To run a System Test:
1 From the Home screen or main menu, press the
[+]
or
[–]
button until
Diagnostics
appears on the top line of the LCD screen. Press the
[Enter]
button to select.
2
System Test
appears on the LCD screen. Press the
[Enter]
button to
begin the test.
The
Test Count
displays the number of load-calibrate-unload cycles
that have been completed during the test.
3 Press the
[Cancel]
button to end the test.
Retrieving Information About the ValueLoader
3
The
Information
menu provides access to information about the
ValueLoader, including the cycle count, event log, and firmware revision.
Cycle Count 3 This option displays the total system cycle count, incrementing each time
a tape is loaded into the drive or exported from the ValueLoader.
To use this option, follow these steps:
Note: At least one cartridge must be in inventory before running
System Test.