PAGE 5
Q U A N T U M I N S T A L L A T I O N
INSTALLATION - LINKED BLINDS
1. Place the tube adaptor on the
chain drive head. Press the
idle end and lift the blind.
2. Fix the outer bracket with the
screws provided.
3. Slide the aligner or the
connector through the
bracket into the idle end.
4. Place the tube adaptor on the
aligner or connector head.
5. Press the spring loaded idle
with locking ring end and lift
the blind and snap it to the
bracket.
6. To align the bottom rails, push
the blind against the idle end
(1), turn the blind, level the
bottom rail with the other one
(2). Release to fix the position
(3).
NOTE: This is not possible
when using the standard
connector set.
7. Fix the blind by turning the
locking ring against the idle
end.
8. Slide the end caps onto the
brackets.
NOTE: The aligner component has an extra metal bearing ring which is only required if the centre space
between two blinds is being extended. For normal installation this can be removed using an allen key.
