Appendix C Automatic Drive Cleaning
Selection of Cleaning Mode
118
Quantum P4000 and P7000 Libraries User’s Guide
Automatic Drive
Cleaning Mode
3
Automatic drive cleaning is disabled by default. In automatic drive
cleaning mode the
library
is responsible for all cleaning functions such as:
• Detecting when a drive requires cleaning
• Tracking and selecting cleaning cartridges
• Moving a cleaning cartridge to the drive
• Determining when a cleaning cartridge has used all of its available
cleaning cycles
• Moving used up cartridges to the load port
Selection of Cleaning Mode
3
The cleaning mode is selectable from the:
•
•
•
The default cleaning mode is host-initiated. A Mode Select command
permanently changes the cleaning mode in the library’s NVRAM, and is
retained if the library power is cycled.
Diagnostic
Software
3
To change automatic cleaning mode from the diagnostic software select
Config
:
•
Enable clean tape
- turns automatic cleaning mode on
•
Disable clean tape
- turns automatic cleaning mode off
Note:
If the libraries are running in a multiple frame configuration, a
cleaning tape must be inside each unit.