Fireball lct10
fireball_lct10_jumper.pdf
Jumper Locations
The Maxtor® Fireball™
lct10
disk drive has only one location where user configurable jumpers are found. The
jumper block is incorporated into the ATA / IDE cable connector. Using the jumper pins you can establish the drive
Master/Slave configuration.
The Maxtor Fireball
lct10
was developed by Quantum Corporation prior to its merger with Maxtor.
BIOS Settings
The following BIOS parameters are provided for customers needing to manually configure the Fireball
lct10
disk
drive. Both base 2 and base 10 capacity values are displayed.
5.1 GB
10.2 GB
15.0 GB
20.4 GB
30.0 GB
Logical Cylinders
10,585
16,383 *
16,383 *
16,383 *
16,383 *
Logical Heads
15 16 16 16 16
Logical Sectors/Track
63 63 63 63 63
Total Logical Sectors
10,002,825 20,044,080 29,336,832 39,876,480 58,633,344
Base 10 Capacity
5,121 MB
10,262 MB
15,020 MB
20,416 MB
30,020 MB
Base 2 Capacity
4,884 MB
9,787 MB
14,324 MB
19,470 MB
28,629 MB
*Note: ATA (IDE) drives with a physical capacity greater than 8.4GB have their default logical C/H/S values limited
to 16,383/16/63 as per the ATA-4 specification. Drives greater than 8.4GB in capacity require LBA support.
Capacity could be restricted to 8.4GB (or less) due to system BIOS limitations. Check with your system or
motherboard manufacturer to determine if your BIOS supports LBA mode for ATA hard drives greater than 8.4GB.
2 of 2