20
Daily Checks
With the controller turned off, check the joystick. Make
sure it is not bent or damaged and that it returns to the
neutral position when you release it. Check the rubber
boot around the base of the joystick for damage. Visually
inspect the boot. Do not handle or try to repair it. See
your Quantum Rehab Provider if there is a problem.
Visually inspect the controller harness. Make sure that
it is not frayed, cut, or has any wires exposed. See your
Quantum Rehab Provider if there is a problem.
Check for flat spots on solid tires. Flat spots could
adversely affect stability.
Inspect the seating system, armrests, and front riggings
for loose hardware, stress points, or damage. See your
Quantum Rehab Provider if there is a problem.
Weekly Checks
Disconnect and inspect the controller from the power
base. Look for corrosion. Contact your Quantum Rehab
Provider if necessary.
Ensure that all parts of the controller system are securely
fastened to your power chair. Do not overtighten any
screws.
Check for proper tire inflation. Pneumatic tires should be
inflated to the psi/bar/kPa air pressure rating indicated
on each tire. If a tire does not hold air, see your Quantum
Rehab Provider for replacement of the tube.
Check the brakes. This test should be carried out on a
level surface with at least 3 feet (1 meter) of clearance
around your power chair.
To check the brakes:
1. Turn on the controller and turn down the speed level of
your power chair.
2. After one second, check the battery condition meter.
Make sure that it remains on.
3. Slowly push the joystick forward until you hear the
electric brakes click. Immediately release the joystick.
You must be able to hear each electrical brake operating
within a few seconds of joystick movement. Repeat this
test three times, pushing the joystick backward, then left,
and then right.
Monthly Checks
Check for drive tire wear. See your Quantum Rehab
Provider for repair.
Check the caster wheels for wear. Replace them as
necessary.
Check the caster forks for damage or fluttering which
indicates that they may need to be adjusted or have the
bearings replaced. See your Quantum Rehab Provider
for repair.
Check the entire power chair for loose hardware and
changes in the function or performance of the power
chair. See your Quantum Rehab Provider for service or
repair.
Keep your power chair clean and free of foreign material,
such as mud, dirt, hair, food, drink, etc.
Spring shocks and gas dampers should be visually
checked for any abnormality, structure damage, or bent
rods. See your Quantum Rehab Provider for repair.
Yearly Checks
Take your power chair to your Quantum Rehab Provider for
yearly maintenance, especially if you use your power chair
on a daily basis. This helps ensure that your power chair is
functioning properly and helps prevent future complications.
Storage
Your power chair should be stored in a dry place, free
from temperature extremes. When storing, disconnect the
batteries from the power chair. See “Batteries and Charging.”
If you fail to store the unit properly, the frame can rust
and the electronics can be damaged. Any corroded
electronic connection should be replaced.
Batteries that are regularly and deeply discharged,
infrequently charged, stored in extreme temperatures, or
stored without a full charge may be permanently damaged,
causing unreliable performance and limited service life. It
is recommended that you charge the batteries periodically
throughout periods of prolonged storage to ensure proper
performance.
You may wish to place several boards under the frame of
your power chair to raise it off of the ground during periods
of prolonged storage. This takes the weight off the tires and
reduces the possibility of flat spots developing on the areas
of the tires contacting the ground.
Disposal of Your Power Chair
Your power chair must be disposed of according to applicable
local and national statutory regulations. Contact your local
waste disposal agency or Quantum Rehab Provider for
information on proper disposal of power chair packaging,
metal frame components, plastic components, electronics,
batteries, neoprene, silicone, and polyurethane materials.
Plastic bags are a suffocation hazard. Dispose of plastic
bags properly and do not allow children to play with them.
Cleaning and Disinfection
Use a damp cloth and mild, non-abrasive cleanser to
clean the plastic and metal parts of your power chair.
Avoid using products that may scratch the surface of
your power chair.
If necessary, clean your product with an approved
disinfectant. Make sure the disinfectant is safe for use
on your product before application.
WARNING!
WARNING!
CARE AND MAINTENANCE
Summary of Contents for Jazzy 1450 Series
