background image

18

BATTERIES AND CHARGING

use. We recommend that you charge the batteries for an 
additional 4 hours after the battery charger indicates that 
charging is complete.

 

„

Infrequent Use

If you use your power chair infrequently (once a week or 
less), you should charge the batteries at least once per 
week for at least 24 hours.

NOTE: Keep your batteries fully charged and avoid 
deeply discharging your batteries. Refer to the 
manual supplied with the battery charger for charging 
instructions. We recommend charging your batteries for 
at least 48 continuous hours once per month to improve 
battery performance and battery life.

How can I get maximum range or distance per charge?

Rarely do you have an ideal driving situation such as smooth, 
flat, hard terrain with no wind, hills, or curves. More often you 
are presented with hills, sidewalk cracks, uneven and loosely 
packed surfaces, curves, and wind. All of these factors will 
affect the distance or running time per battery charge. Below 
are a few suggestions for obtaining the maximum range per 
charge:

 

„

Always charge the batteries fully prior to your trip.

 

„

Plan your trip in advance to avoid inclines if possible.

 

„

Limit baggage weight to essential items.

 

„

Try to maintain an even speed and avoid stop-and-go 
driving.

 

„

We recommend charging your batteries for at least 48 
continuous hours once per month to improve battery 
performance and battery life.

What type of batteries should I use?

We recommend deep-cycle batteries that are sealed 
and maintenance free. Both AGM and Gel-Cell are deep-
cycle batteries that are similar in performance. Refer to 
the specifications table for more information regarding the 
batteries used with your power chair.

Corrosive chemicals contained in batteries. Use only 
AGM or Gel-Cell batteries to reduce the risk of leakage 
or explosive conditions.

Why do my new batteries seem weak?

Deep-cycle batteries employ a much different chemical 
technology than that used in car batteries, nickel-cadmium 
(nicads), or in other common battery types. Deep-cycle 
batteries are specifically designed to provide power, drain 
down their charge, and then accept a relatively quick 
recharge. AGM and Gel-Cell batteries should be charged as 
often as possible. They do not have a “memory” like nickel-
cadmium batteries.

WARNING!

We work closely with our battery manufacturer to provide a 
battery that best suits your power chair’s specific demands. 
Fresh batteries arrive regularly at Quantum and are promptly 
shipped with a full charge. During shipping, the batteries 
encounter temperature extremes that may influence initial 
performance. Heat robs the charge from the battery, and 
cold slows the power available and extends the time needed 
to recharge the battery (just as with a car battery).

It might take a few days for the temperature of the battery 
to stabilize and adjust to its new ambient temperature. More 
importantly, it will take a few “charging cycles” (a partial 
drain—then a full recharge) to establish the critical chemical 
balance that is essential to the battery’s peak performance 
and long life. It will be well worth it to take the time to break 
in your battery properly.

How can I ensure maximum battery life?

A fully charged deep-cycle battery will provide reliable 
performance and extended battery life. Keep your power 
chair’s batteries fully charged whenever possible. Batteries 
that are regularly and deeply discharged, infrequently 
charged, or stored without a full charge may be permanently 
damaged, causing unreliable power chair operation and 
limited battery life.

NOTE: The useful life of a battery is quite often a reflection 
of the care it receives.

How should I store my power chair and its batteries?

If you do not use your power chair regularly, we recommend 
maintaining battery vitality by charging the batteries at least 
once per week.

If you do not plan on using your power chair for an extended 
period, fully charge the batteries prior to storage. Disconnect 
the battery harnesses and store the power chair in a warm, 
dry environment. Avoid temperature extremes, such as 
freezing and excessively hot conditions, and never attempt 
to charge a frozen battery. A cold or frozen battery should be 
warmed for several days prior to recharging.

What about public transportation?

AGM and Gel-Cell batteries are designed for application in 
power chairs and other mobility vehicles. These batteries are 
Federal Aviation Administration (FAA) approved, allowing 
safe transportation on aircraft, buses, and trains, as there is 
no danger of spillage or leakage. We suggest you contact the 
carrier’s ticket counter in advance to determine that carrier’s 
specific requirements.

What about shipping?

If you wish to use a freight company to ship your power 
chair to your final destination, repack your power chair in the 
original shipping container and ship the batteries in separate 
boxes.

Summary of Contents for Jazzy 1450 Series





























Reviews: