Seat Position
You can move the seat forward or rearward by changing the extrusion
mounting position.
To change the position:
1. Turn off the power to the controller.
2. Make sure the power chair is in drive mode.
3. Unplug the controller connector(s) from the power base.
4. Remove the seat from the power base.
5. Remove both extrusions from the bottom of the seat.
6. Reposition the extrusions on a different set of mounting holes. You
must move both extrusions the same number of holes either forward or
backwards.
See fi gure 12.
7. Fasten the extrusions back onto the bottom of the seat.
8. Reinstall the seat.
9. Reconnect the controller to the power base.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you can adjust the
seatback angle with the seatback release lever. The lever is located on the
right side of the seat base.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
4. Flip up the seat latch safety.
See fi gure 6.
5. Squeeze the seat latch and release the seat from the front trapeze bar.
6. Slide the seat forward and remove it from the power base.
7. Remove the hardware that attaches the trapeze bars to the seat
interface weldments.
See fi gure 11.
8. Move the trapeze bars up or down to the desired height.
NOTE: Change the seat dump by raising or lowering only one trapeze
bar (front or rear).
9. Reinstall the hardware.
10. Reinstall the seat.
11. Reconnect the controller to the power base.
Summary of Contents for edge 2.0
Page 1: ...Owner s Manual ...
Page 4: ... Identification Key 11 9 10 8 12 A B 1 3 13 2 4 5 7 6 ...
Page 45: ... ...
Page 46: ... ...
