![background image](http://html1.mh-extra.com/html/quantum/dxi6900-s/dxi6900-s_installation-manual_3781023046.webp)
Performing Initial Configuration
Quantum DXi6900-S Installation Guide
46
Performing Initial Configuration
Before the DXi6900-S is operational, you must configure the system through the remote management
console. You must also configure your backup software.
Configuring the DXi6900-S consists of four major steps. See the following subsections for detailed
instructions for completing each step:
l
Performing Initial Configuration
l
Completing the Getting Started Wizard
l
l
Connecting the Ethernet Cables
l
l
Installing the Capacity License
l
Completing the Getting Started Wizard
To complete the DXi6900-S Getting Started wizard:
1. On the service laptop, open a supported Web browser, type
10.17.21.1
in the
Address
box, and press
<Enter>
.
The
Login
window displays (see Figure 37 on the next page).
Additional Information
l
For Web browsers, the DXi6900-S supports Firefox 36 or higher, Chrome 40 or higher, or
Internet Explorer 10 (with SSL 3.0 disabled) and higher.
l
If you are experiencing browser issues, please update to the latest browser version.
l
If the
Login
window does not display, verify that you entered the correct IP address (
10.17.21.1
).
Also make sure that the service laptop is connected to the service port on the Node, and that the
network settings on the laptop are correct (see Accessing the Service Menu
). Wait
ten minutes, then try again.