Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Replication CLI Commands
49
VTL
name
=
test1
replication
state
=
Enabled
replication
sync
id
=
last
replication
start
=
Thu
Mar
5
11:02:03
2009
last
replication
completion
=
Thu
Mar
5
11:02:07
2009
last
replication
status
=
Success
last
synchronization
start
=
last
synchronization
completion
=
last
synchronization
status
=
Listing Deduplicated
NAS on the Source
syscli --list dedupnas [--name <sharename> |--namematch <pattern>]
This CLI command returns the list of deduped NAS shares on the source.
CLI command options:
•
--list
: Lists all deduped NAS shares on source.
•
--name
: if specified, lists info for this share only.
•
--namematch
: if specified, only shares whose names match the specified
pattern are listed. The wild characters
^
and
$
are supported as follows:
• ^xxx – matching pattern xxx at the start of names
• xxx$ – matching pattern xxx at the end of names
Remember to escape
$
with a backslash because it is special to the shell. For
example, to list all shares ending with
test
in the names, type the following
command:
syscli --list dedupnas --namematch test\$
Listing Replicated VTL
on the Target
syscli --list repvtl
This CLI command allows the CLI admin to display a list of all the replicated
virtual tape libraries (VTLs) that have been performed on the system as a target.
The list includes the virtual tape library name, source hostname IP address, the
replication status (i.e. start, completion and status).
An example output of this command:
List
of
all
replicated
VTL
on
the
target.
Total
count
=
1
[replicated
vtl
=
1]
ID
=
1
VTL
Name
=
test1
Source
Host
=
Galaxy3.node
-
1
Replication
Started
=
Thu
Mar
5
13:08:59
2009