DX3000 and DX5000 Quick Start Guide
5
Figure 5 Assembling the Rack
Rails
2
Install the left and right chassis support brackets at the
beginning of a hole pattern (see
Locating the Mounting
Position
) and secure as follows (see
figure 6
):
•
DX3000
- One 10-32 x .50 in. Slotted screw with
and a three hole nut plate on each rail at the front
and back of the rack. 10-32 x .50 in. PHILLIPS
screws and nuts are also provided for racks with
threaded holes.
N
OTE
:
The support brackets extend to accommodate
rack depths or 30 to 36 in. (76.2 to 91.4 cm).
N
OTE
:
The DX3000 support brackets must be installed
on the inside rack rails.
DX3000:
The brackets are
secured with four #8 PHILLIPS
screws and four nuts.
DX3000
: Bracket (short
brackets pre installed)
DX5000:
Adjustment
screws; adjusts to
the depth of your
rack
DX5000:
Front mounting
bracket preset. Ensure the
screws are in the correct
position.
DX5
000 r
ack r
ails
DX3
000 r
ack r
ails
•
DX5000
- Two 10-32 x .50 in. PHILLIPS screws on
each rail at the front and back of the rack for the
DX5000.
Figure 6 Installing the Chassis
Support Brackets (DX3000 and
DX5000)
3
Once the rails are secured to the rack, tighten the rail
adjustment nuts on each rail.
4
With the support brackets installed, prepare the chassis
mounting holes if necessary (see
figure 7
for hole
location). These are the holes used to secure the chassis
to the rack.
N
OTE
:
Ensure that clip nuts are installed on the rails (see
figure 4
) prior to installing the DX5000 rails.
DX5000
support
brackets
DX3000
support
brackets
10-32 x .50
PHILLIPS
screws
Clip nuts
Three hole nut
plate, use
bottom hole
10-32 x .50
slotted
screw