Chapter 4 Power Supply
Installing a Power Supply
2U Rackmount Component Replacement Guide
38
c
While holding the fan module up, pull the tape drive power cable
assembly under the fan module and through the slot in the fan
mounting wall.
6
Seat the fan module in the unit, and then install the thumbscrew
securing the fan module to the unit.
7
Connect the tape drive power cable assembly to the rear panel of the
tape drive.
8
Replace the 2U Rackmount cover (see
Replacing the Cover
on
page 5).
9
Slide the 2U Rackmount back into the equipment rack and secure it to
the rack (see
Sliding the 2U Rackmount Into the Equipment Rack
on
page 4).
10
Connect the 2U Rackmount power cable at the rear panel (see
Connecting Power
on page 3).
11
Turn on power to the unit by pressing and holding the power button
on the front panel for one second.
12
Turn on any peripheral devices you turned off earlier.
13
Turn on the host computer.
Note:
Be sure to align the power cable connector so that it
passes through the slot easily.
Caution:
The fan mounting flange is sharp. To avoid
personal injury or damaging the power cable
assembly or connector, apply only light pressure
when pulling the cable through the fan mounting
wall.