Quantum DLT 2000, Product Manual

Page: 36 / 345

Installing and Configuring the DLT2000 Tabletop Drive
2-10 DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem
2.7 DLT2000 Troubleshooting Chart
If the DLT2000 fails during POST or operation, use Table 2-4 to determine the
problem and the action to take.
Table 2-4 DLT2000 Troubleshooting Chart
If. . . Then . . . You should. . .
Your system does
not recognize the
DLT2000 Your system might not
be configured to see
the SCSI ID Configure your system to see the
ID.
The SCSI ID might
not be unique Change the SCSI ID and
reconfigure the system. New ID
effective at next power-on.
The parameters for
your SCSI adapter
might be incorrect Check your SCSI adapter
installation.
The SCSI signal cable
might be loose Make sure the connector on each
end of the cable is fully seated.
The SCSI terminator
might not be present or
might be loose Install the terminator; make sure
the terminator is fully seated.
The SCSI bus might
not be correctly
terminated If the DLT2000 is the last or only
device on the bus, make sure the
terminator is installed on the
DLT2000.
If the DLT2000 is not the last or
only device on the bus, check the
cable connections and make sure
the terminator is installed at the
end of the bus.
The SCSI terminator
might not be at the
end of the bus, or
more than two
terminators might be
present Be sure to install a terminator at
each end of the bus. One
terminator is usually installed at
the system.