Quantum 4000 Enhanced, Installation And Operation Manual

Page: 50 / 88

5-10 Operation and Maintenance
62-0162-01
Whenever the system is
writing to a tape, these two
messages will alternate.
Each message will be
displayed for
approximately 2.5 seconds.
Whenever the system is
reading a tape, this
message will alternate with
the ready screen.
Whenever a tape is in
motion.
DLTtype = DLT
TM
4000 (4000DLT), or DLT
TM
7000
(7000DLT).
Compressed if compression mode enabled, standard
if compression mode disabled.
Writing – indicates the system is writing to the tape.
2.1:1 – indicates the current compression ratio being
used.
16GB – indicates the amount of tape still available to
be written to.
3 arrows in motion (
) – indicate tape travel.
Reading – indicates the system is reading from the
tape.
Motion Messages = Loading, Unloading, Reading,
Writing, Positioning, Erasing, Cleaning and
Rewinding.
3 arrows (
) – indicate tape travel.
Whenever an incorrect
cartridge type is placed into
a drive.
The LCD will flash and the beeper will sound while
this message is displayed.
Press the Unload button, the drive will begin
unloading the tape and the LCD will return to
normal operation messages.
Table 5-4 Drive Operation LCD Messages