3
BOARD PREPARATION
The E510 eval board can be adhered to plastic, glass, or any other dielectric panel. If you
wish to use the supplied user panel, please follow the steps below:
1
Use normal ESD precautions when working with the
E510!!
2
Place the user panel face down on a table-
Tape down the edges of the panel so it cannot move
while you work with it.
3
Remove the paper backing from the E510 Board
and adhere it to the rear of the user panel. Bend the
PCB slightly as shown while smoothing it to remove
any air bubbles.
Tip:
Line up the PCB with the alignment marks
on the back of the slider panel.
The PCB must
be positioned with the connector on the
underside of the QWheel
™
logo.
The Board
does allow some flexing, but care must be taken
not to bend it too far as this will crack the solder
joints.
4
Un tape the user panel from the table and mount the
four rubber feet as shown to make the E510
mechanically stable in use.
