Vibe
www.quantumrehab.com
43
V I I I . O P E R A T I O N
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. Your Dynamic DX controller
was pre-programmed at the factory for five drive programs 1 (slowest) to 5 (fastest). The drive mode is indicated by a
number in the center of the keypad.
NOTE: The drive mode settings are pre-set at the factory. If your Quantum Rehab Specialist changes these
settings, please make note of these changes.
To change the drive mode program:
1. Press the drive program select key.
2. Move the joystick right to increase the drive mode program.
3. Move the joystick left to decrease the drive mode program.
4. Press the drive mode select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a seven-segment light that displays the drive program. It also displays a drive inhibit and actuator mode (if appli-
cable), when they occur. This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has
occurred. See Out Of Neutral At Power Up.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the remote keypad. Contact your Quantum Rehab Specialist for information on how to operate these acces-
sories.
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights), the controller will reduce power chair performance
to conserve battery power.
Off-board Charger/Programming Socket
You charge the power chair batteries through the 3-pin socket located on the front of the Europa. Off-board charger
current should not exceed 8 amps. Contact your Quantum Rehab Specialist for more information.
NOTE: The socket may also be used for reprogramming the Europa. Contact your Quantum Rehab Specialist
for more information.
Sleep Mode
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main
power if the joystick is not moved in any direction for a specific amount of time. This time factor is programmed into the
controller. The battery condition meter on the keypad indicate sleep mode by blinking once every five seconds. To restore
power and continue, push the on/off key twice.
