Vibe
www.quantumrehab.com
23
V I . C O M F O R T A D J U S T M E N T S
11. Remove the front shroud from the power base. See figure 11.
12. Remove the detent pin from the front trapeze bar.
13. Raise or lower the front trapeze bar to the desired position.
NOTE: To change the angle, set either the front or rear
trapeze bar higher or lower than the other.
14. Reinstall the ball detent pin into the front trapeze bar.
15. Place the seat back onto the trapeze bars.
16. Use the turnbuckle to adjust the front trapeze bar so that it
fits into the front extrusion snugly. See figure 12. Loosen the
locknuts on the turnbuckle. Then turn the turnbuckle
clockwise to adjust the front trapeze bar backward or turn it
counterclockwise to adjust the front trapeze bar forward.
When you are finished adjusting the front trapeze bar, tighten
both locknuts.
17. Reinstall the front shroud.
18. Reconnect the controller.
19. Close the battery door and secure the battery door latches.
Seat Position
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Remove the seat.
2. Remove both extrusions from the bottom of the seat. See
figure 8.
3. Reposition the extrusions on a different set of mounting holes.
See figure 13. You must move both extrusions the same number
of holes either forward or backward.
4. Fasten the extrusions back onto the bottom of the seat.
5. Reinstall the seat.
Reclining Seat
If your Vibe is equipped with a reclining seat, you can adjust the
seatback angle with the seatback release lever. The lever is lo-
cated on the right side of the seat base.
To adjust the seatback angle:
1. Push down on the lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
Figure 11. Front Shroud Removal
Figure 12. Front Trapeze Bar Adjustment
Figure 10. Rear Trapeze Bar Adjustment
LOCK NUT
TURNBUCKLE
LOCK NUT
REAR TRAPEZE BAR
BALL DETENT PIN
BALL
DETENT
PIN
BALL DETENT PIN
FASTENERS
FRONT TRAPEZE BAR
