Quantum Dynamo
www.quantumrehab.com
23
I V . D I S A S S E M B L Y A N D A S S E M B L Y
4. Keep pulling upward until the locating pin on the bottom of the
front frame releases from its slot in the power base frame
assembly.
5. Carefully let the power base frame assembly tilt to a resting
position.
6. Repeat for the other power base frame assembly.
ASSEMBLY
To assemble the front frame and power base frame:
1. Place the three frame assemblies next to each other as shown
in figure 15.
2. Grasp the front frame and fit the notch on the front frame bottom
bar onto the locating pin on the lower section of the power
base frame assembly. See figure 16.
WARNING! The front frame should be
positioned with the two semicircular notches
in the vertical bar facing forward.
3. Pivot the front frame top bar toward the power base frame
assembly and push the front frame top bar onto the locking
mechanism until the two assemblies snap securely into place.
See figure 14.
4. Repeat for the other power base frame assembly.
WARNING! Make certain that the front frame
is snapped securely to both the right frame
assembly and to the left frame assembly.
To install the battery well frame:
1. Hold the battery well frame so that the bottom of the well hangs
downward.
2. Position the notches on the front of the battery well frame onto
the locating pins on the front frame bottom bar. See figure 16.
3. Fit the notch on either side of the rear of the battery well frame
onto the locating pin on each power base frame assembly.
4. Make certain that the locking mechanisms snap securely into
place.
Figure 13. Removing Battery Well Frame
Figure 14. Fitting the Frames
