Quantum Data Gen 2 980, User Manual

Page: 163 / 315

980 HDMI Protocol Analyzer User Guide Rev. A1
Page 163 December 19, 2012
In the example shown below there are not errors.
7.5 Running the Pseudo-Random Noise Test through the command line
You can run the Pseudo-Random Noise test through the command line. Refer to the Chapter Command Line
Interface for Capturing Data for information on how to establish a command line session with the 980.
Commands for Pseudo-Random Noise Test
Note: Commands are not case sensitive.
Command Description Syntax Command Example
PRNG:NFRS Set number of frames to analyze in
pseudo-random noise test PRNG:NFRS
< frames >
Where < frames > is the number of
frames to capture and compare during
the test. Enter 0 to run the test in
continuous mode which requires user
intervention to stop.
To set number of frames to
analyze in pseudo-random noise
test:
> PRNG:NFRS 50