Setup
Turning on the Cubiscan
Cubiscan 110-XT
16
Turning on the Cubiscan
Specific procedures must be followed each time you turn on the Cubiscan
110-XT, as follows:
1. Make sure there are no packages or other objects on the Cubiscan
platform.
2. Turn on the Cubiscan 110-XT via the power strip (see
).
NOTE
The Cubiscan performs self-calibration and diagnostic procedures that
take about five seconds. Do not touch the Cubiscan platform during these
five seconds.
Connecting to a computer or network
To operate the Cubiscan 110-XT, you can connect it to a computer or a
network, or you can use the display, as follows:
•
Connect it via an USB to USB cable. Use Qbit software on the computer
to run the Cubiscan 110-XT.
•
Connect it to a host system via a standard 10-BaseT Ethernet TCP/IP
port.
•
Connect it to a PC using a serial RS-232 cable.
USB connection
Complete the following steps to connect the Cubiscan 110-XT to a
computer using a USB connection. The USB connection method is the
recommended method, and all materials needed for communicating with a
computer are supplied.
1. Place the computer in its permanent location, generally close to the
Cubiscan. (Refer to
2. Route the USB cable so it cannot be crushed, bent, or pulled loose.
3. Connect one end of the USB cable to the USB connector on the
bottom edge of the freestanding display, as shown below.
