16
Rev 04-2009
SERVICE MANUAL
4- DISASSEMBLING
A
4.
Tighten completly the 2 screws A.
5.
Continue to slide the 4 screws without heads inside the tubes by
screwing without never tight them. The pressure of these screws
on the glass must be at the minima.
WARNING :
Never tighten hardly these screws.
A too high pressure of the screw rods on the screen can
break the tactile glass or causes disfunctioning of it.
6.
When the screws are in a ligth contact with the top of the tube,
keep the screws in position with an Allen key and lock this position
with the nuts.
CAUTION :
After the screen assembly mounting, a touch screen calibration
must be performed (see chapter 5-1 Touch screen calibration).
Summary of Contents for Aviso
Page 2: ......
Page 8: ...8 Rev 04 2009 SERVICE MANUAL 3 OVERALL BLOCK DIAGRAM ...