Quanta Computer STRATOS S400-X44E, Technical Manual

Page: 244 / 251

S
AFETY
I
NFORMATION
E
LECTROSTATIC
D
ISCHARGE
(ESD)
9-7
Electrostatic Discharge (ESD)
Always handle boards carefully. They can be extremely sensi-
tive to ESD. Hold boards only by their edges. After removing a
board from its protective wrapper or from the server, place the
board component side up on a grounded, static free surface.
Use a conductive foam pad if available but not the board wrap-
per. Do not slide board over any surface.
Other Hazards
Battery Replacement
Cooling and Airflow
CAUTION!
ESD
CAN DAMAGE DRIVES
,
BOARDS
,
AND OTHER PARTS
. W
E REC
-
OMMEND THAT YOU PERFORM ALL PROCEDURES AT AN
ESD
WORK
-
STATION
. I
F ONE IS NOT AVAILABLE
,
PROVIDE SOME
ESD
PROTECTION BY WEARING AN ANTISTATIC WRIST STRAP ATTACHED
TO CHASSIS GROUND
--
ANY UNPAINTED METAL SURFACE
--
ON
YOUR SERVER WHEN HANDLING PARTS
.
CAUTION!
T
HERE IS THE DANGER OF EXPLOSION IF THE BATTERY IS INCOR
-
RECTLY REPLACED
. W
HEN REPLACING THE BATTERY
,
USE ONLY THE
BATTERY RECOMMENDED BY THE EQUIPMENT MANUFACTURER
.
!
!
CAUTION!
D
ISPOSE OF BATTERIES ACCORDING TO LOCAL ORDINANCES AND
REGULATIONS
.
CAUTION!
D
O NOT ATTEMPT TO RECHARGE A BATTERY
.
CAUTION!
D
O NOT ATTEMPT TO DISASSEMBLE
,
PUNCTURE
,
OR OTHERWISE
DAMAGE A BATTERY
.
CAUTION!
C
AREFULLY ROUTE CABLES AS DIRECTED TO MINIMIZE AIRFLOW
BLOCKAGE AND COOLING PROBLEMS
. F
OR PROPER COOLING AND
AIRFLOW
,
OPERATE THE SYSTEM ONLY WITH THE CHASSIS COVERS
INSTALLED
. O
PERATING THE SYSTEM WITHOUT THE COVERS IN
PLACE CAN DAMAGE SYSTEM PARTS
. T
O INSTALL THE COVERS
:

Check first to make sure you have not left loose tools or
parts inside the system.

Check that cables, add-in cards, and other components are
properly installed.

Attach the covers to the chassis according to the product
instructions.
!
!
!
!