QBOX-100P Series - User Guide, Rev. 1.0
// 26
5.1.
Opening and Closing the QBOX-100P Series
Before opening the QBOX-100P Series, the system must be switched off and
disconnected from the main power supply. Also, disconnect all peripheral devices from
the QBOX-100P Series. Before you begin, ensure that you have a clean, flat and ESD-
safe surface to work on.
For opening and closing the QBOX-100P Series, please perform the following steps:
1.
Close all applications. Shut down the system properly and disconnect the connection to the main power source.
Disconnect all peripherals.
2.
The QBOX-100P Series should lay on a flat, clean surface with the access cover facing upwards.
3.
Loosen and remove the Phillips screws (three located on the top side), that secure the access cover to the
chassis. Retain the screws for later use.
Figure 5: Descrewing the access cover of the QBOX-100P Series
4.
Lift the access cover up.
5.
Now you have access to the internal SATA connector in order to remove or install the HDD / SSD drive.
6.
Loosen and remove the Phillips screws (four located on the corners of the baseboard), that secure the baseboard
to the chassis. Retain the screws for later use.
Figure 6: Descrewing the baseboard of the QBOX-100P Series
