SOFTPRO INSTALLATION GUIDE
©2022 SoftPro Water Systems. All rights reserved.
29
.
Do not use pipe dope or plumbers’ putty. This can damage the plastic fittings.
Then slide both elbow connection adapters into the bypass valve. Then re-install the remaining two red clips to
lock in place. Gently tug on the clips to make sure they are locked into place.
5)
Make sure that the bypass valve is set to the bypass position.
2) PREPARE FOR THE INSTALLATION OF THE
NEW WATER SOFTENER
ℹ
Using Additional Whole House Filters Or Other Treatment Systems?
If you have additional water treatment filters (i.e. whole house filter, iron filter or pH neutralizer), those systems should
always be installed before the water softener.
The water softener is the final treatment systems in your complete water treatment. (The exception is for a UV Disinfection
System, which will be placed after the water softener.)
1)
Verify and clear the location of the new water softener system.
a.
Clear and clean the areas.
b.
Prepare the nearest electrical outlet and drain locations. Verify the drain type for connection and applicable
parts to be required.
c.
Prepare the softener’s inlet and outlet water pipe connections.
2)
Switch-off the breaker to the hot water heater.
At the electrical control panel, temporarily switch off the power feeding the water heater unit.