7
6
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Step 2 - Assembling the upper handles (continued)
Assembly
WARNING!
Make sure that the throttle switch is on the same side as the cable from the deck and
that they are not twisted.
1. Slide the cord retainer onto the upper hand grip via the left hand handle pole, sliding it around
to the top of the handle so it does not fall off during the following assembly steps.
2. Slide the upper handle into the profiled area of the lower handle frame. Make sure that the
holes of both sides off the upper handle are directly aligned with the holes of the frame.
3. Secure the upper handle to the lower handle frame with the wing-nuts and bolts provided.
Step 3 Securing the power cord with cable clip
1. Secure the power cable to the frame using the cable clips. Use one clip on the upper handle
frame and the second on the lower handle frame.
Assembly
Step 4 - Fitting the grass box
Locate the mounting bar of the bag into the groove of the main deck.
Step 5 - Connection to the power supply
WARNING!
Read all of the instructions of this manual before connecting the power supply for
your tool.
WARNING!
If the insulation on a power cable or extension lead is found to be cut or damaged,
do not touch it! Disconnect the power supply immediately and have the damaged cable replaced
by authorized service agent.
WARNING!
If operating the appliance in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
WARNING!
Use only extension cords suitable for outdoor use, preferably with a high visibility
cable colour.
Always unwind all extension cables fully, coiled cables can overheat and reduce the
efficiency of your product.
NOTE!
For extension cables up to 15metres, use a wire cross section of 1.5mm
2
. For extension
cables over 15 meters but less than 40 meters, use a wire cross section of 2.5 mm
2
WARNING!
This product is designed to operate on 230-240 VAC 50Hz. The voltage and current
must comply with the information on the ratings label!
NOTE!
This electric cylinder mower is fitted with a non-rewireable plug.If it is necessary to
change the fuse in the plug,the fuse cover becomes lost or damaged,the plug must not be used
until a suitable replacement is obtained.
WARNING!
A 13amp fuse must be fitted.
1). Make sure the on/off switch is in its off position.
2). Double the extension cord, about a foot from the end. Push the loop through the hole on the
rear safe guard and hook the loop over the cord restrainer. Gently pull on the cord to ensure
that it is firmly attached at the handle.
3). Connect the cord to a suitable socket.
