Qualcast Q-EBH 750, Operating Instructions Manual

Page: 12 / 14

10
Maintenance and cleaning work on the machine as well as
removal of the safety devices may only be performed when
the motor is switched off and the power cable has been
pulled. Worn out or damaged hoe blades should only be
replaced by an authorized professional (see address on
warranty certificate).
Do not clean the tool with running water - and particularly
not with a pressure hose.
Ensure that all mounting components (i.e. screws, bolts, nuts
etc.) are always tightened so that the machine can be safely
operated at all times.
Store the device in a dry room. All the metal parts should be
cleaned and then oil to ensure that they provide a long life.
For best results, clean the plastic parts of the machine with a
brush or rag. Do not use any solvents to remove dirt.
At the end of the season, perform a general inspection of the
machine and remove any deposits which may have
accumulated. At the start of each season, ensure that you
check the condition of the machine. If repairs are necessary,
please contact one of our customer service centers (see
address on warranty certificate).
9. Replace the tiller blades
For safety reasons, we recommend having the tiller blades
replaced by an authorized professional (see address on
warranty certificate).
Important
!
Wear working gloves. Use only genuine spare parts since
otherwise the function and safety of the machine cannot be
guaranteed.
Please quote the following data when ordering replacement
parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
Helpline numbers:
UK 0151 649 1500
IRE 189 094 6244
8. Maintenance, care and storage 10. Ordering replacement parts
11. Technical data
Voltage 230V ~ 50Hz
Power input 750 W
Working width 30 cm
Tiller diameter 22 cm
Idle speed 400 rpm
Number of blades 4 pieces
LpA noise level 70 dB(A)
LWA peak noise level 93 dB(A)
Vibration at the handlebars ahv
≤
2.5 m/s
2
12. Troubleshooting Guide
Fault Possible causes Remedy
Motor does not start a) No power at the plug a) Check the power cable and fuse
b) Cable defective b) Check
c) Switch/plug block defective c) By customer service workshop
d) Motor terminals or capacitor d) By customer service workshop
disconnected
e) Excessive working depth e) Reduce working depth
Motor performance drops a) Soil too hard a) Correct working depth
b) Blades badly worn b) Replace hoe blades
Important note!
For protection, the motor is equipped with a thermal switch
which cuts out when the motor is overloaded and switches
on again automatically after a short cooling period.
Helpline No. UK 0151 649 1500 / IRE 189 094 6244 Helpline No. UK 0151 649 1500 / IRE 189 094 6244