Products sold in GB only:
Your lawnraker is fitted
with an approved 13 A (BS1363/A) electric plug
and is protected by a 3 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket out-
lets, it should be cut off and an appropriate plug fit-
ted in its place.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
Fix the handle bottom
6
to the body of the mower
using pivot pins
12
. Ensure that the pivot covers
11
are fitted to the handle bottom
6
. (figure
A
)
Attach the handle top
1
with the bolts and the wing
nuts to the handle assembly.
Note: Ensure that the cable clips supplied are used
to fix the cable to the handle, as in figure
A
.
Attach cable to cable restraint
5
as in figure
B
en-
suring that sufficient cable slack is available. (For
products not sold in GB)
Grassbox/bag
Attach/remove the grassbox as shown in figure
C
.
Ensure the cable is not trapped when folding/un-
folding top handle.
Do not drop the handles.
The lawnraker can be set to several operating
heights. For this purpose,
➊
pull the height of rake
lever
9
outward then
➋
move up or down to the
desired raking height while supporting the weight of
the lawnraker with the other hand.
Depending on grass height and conditions set scar-
ifying/raking height as shown:
●
= tougher material
❍
= lighter material
The tines continues to rotate for a few sec-
onds after the machine is switched off. Allow
the motor/tines to stop rotating before
switching “on” again.
Do not rapidly switch off and on.
To aid starting push handle down to lift front
wheels.
Starting:
Press and hold the safety button
3
.
Squeeze the switch lever
2
towards
the handle.
Release the safety button
3
.
Stopping:
Release the switch lever
2.
Assembly
Adjusting the Cutting Height
(Figure D)
height
(mm)
Moss
Thatch
etc.
Leaves
Twigs
etc.
- 3
●
2
●
7
❍
❍
12
❍
●
17
●
22
●
27
●
Starting and Stopping (Figure E)
0
I
2
1
➊
➋
Lawnraker 32 Seite 3 Montag, 23. Februar 2004 2:56 14
