Quadro PG-M355 User Manual Download

Page: 6 / 24

- 4 -

Steam ironing

•

Place the iron in the vertical position and set the temperature control dial (I) to the minimum / low

heat setting.

•

Insert the plug into the socket, and then turn the temperature control dial (I) to the “high heat” marking.

The pilot light (G) will come on, indicating that the iron is heating up.

•

When the pilot light turns off, the set temperature has been reached and the iron is ready for use.

•

During ironing, the pilot light on the iron automatically switchs on / off as the thermostat maintains

the desired temperature (you may continue ironing as normally during that process).

•

Turn the steam control turning knob (C) to the required position.

•

Steam is produced as soon as the iron is held horinzontally.

Note:

The Steam function can only be used at high temperature (MAX position temp.control dial).

Spraying

•

Press the spray button (E) to spray water on clothes, as often as required.

Note:

When using the water spray function, ensure that there is enough water in the water tank,

and you may have to pump the spray button several times at first use in order to start the spraying
function.

Burst or vertical steam ironing

•

Press the burst of steam button (D) to generate a powerful burst of steam that can penetrate the

fabrics and smooth the most difficult and tough creases. Wait for a few seconds before pressing
again.

•

By pressing the burst of steam button at intervals you can also iron vertically (curtains, hung

garments, etc.)

Note:

The burst steam function can only be used at high temperature. Stop the emission when the pilot

light turns on, the start ironing again only after the pilot light has turned off.

Dry ironing

For ironing without steam, follow the instruction in the section “steam ironing”, however, the steam
control turning knob should remain in the position “0” (no steam).

Cleaning the soleplate of your iron

Do not use harsh abrasives, chemical cleaners or solvents to clean the exterior of your iron
because they will damage the surface.

After each use, allow your iron to completely cool down before wiping the soleplate with a soft damp
cloth.  If  polyester  has  burnt  to  the  soleplate,  iron  a  damp  cotton  cloth  while  your  iron  is  still  hot.  If
necessary,  allow  your  iron  to  completely  cool  down  then  wipe  over  the  soleplate  with  a  soft  cloth
moistened  with  methylated  spirits.  Wipe  off  the  methylated  spirits  with  a  damp  cloth  then  dry  the
soleplate.

Self-cleaning

Only press the self-clean button (J) when you want to activate the self cleaning system. Never press the
self-clean button when ironing.
The self-clean function removes scale and impurities. Use the self-clean function once every two weeks.
If the water in your area is very hard, the self clean function should be used more frequently.

1.  Ensure your iron is switched off and unplugged from the mains supply socket.
2.  Set the steam control turning knob to position O (no steam).
3.  Place the iron on a surface in upright standing position.

ENGLISH