10
ENGLISH
OPERATION
OPERATION/CLOCK SETTING
OPERATION/TUNER
POWER STANDBY ON/OFF
STANDBY
MEMORY/CLK ADJ
MEMORY/CLK ADJ
MEMORY/CLK ADJ
TUNING
STANDBY
FUNCTION
STOP/BAND
PROGRAMMING OF PRESET STATIONS
STOP/BAND
MEMORY/CLK ADJ
ALBUM/PRESET DN
ALBUM/PRESET UP
MEMORY/CLK ADJ
TUNING TO PRESET STATIONS
ALBUM/PRESET DN
ALBUM/PRESET UP
.
When you first plug the unit into the mains, the unit will go into standby mode.
The display will show the time.
•
You can press
to switch on the unit.
•
The standby function of the unit remains on until the unit is switched on.
•
Pull the main plug out of the wall socket if you want to switch off the main
voltage completely.
1. Under power standby mode, press
key to access clock
setting.
2. The hour digit will flash, press
or
to set the correct hours.
3. Press
again to select the minutes setting, minute digit
will flash, press
or
to set the correct minutes.
4. Press
again to store in the memory.
1. Press
to switch on the unit or remote.
2. Press
to select the TUNER mode.
3. Select the tuning range with the
button.
4. Press
or
for few seconds, then release the button.
•
The tuner will automatically search for the first transmitter of sufficient
strength.
•
Repeat this procedure if you wish to select another station.
5. To tune to weak stations, briefly depress
or
continuously until you
read the correct frequency or the reception is at its optimum.
6. Switch to MONO if there is interference noise during FM STEREO reception.
1. Select the tuning range with the
button.
2. Tune to the desired station as described under Tuning.
3. Press
. "06" will start to flash and "MEMORY" will
display.
4. Press
or
to assign a number
(FM 1-30 / AM 1-15) to the preset station.
5. Press
again. The frequency, preset number and stereo
setting are now entered in the memory.
6. Repeat this procedure to store other frequencies and preset in the memory.
Select a number(FM 1-30 / AM 1-15) by pressing:
or
button
