Once the front header is secured, go to
the rear corner of the Top deck and lo-
cate the rear corner straps. Thread the
straps down and under the seat belt
mount as shown in FIGs 28 & 29 and
thread the strap through the buckle
(FIG30). Repeat this on the other side of
the vehicle and while pulling towards
the rear of the vehicle, tighten one strap
and then the other side strap tightening
up the top deck. Do not tighten com-
pletely (FIG31).
8
Step 5: Installing the Top Deck to the Jeep
®
(continued)
Pull the top down to engage the header
clamps on each side of the windshield
and secure the Header to the windshield
(FIGs 25, 26 & 27).
FIG26
FIG27
IMPORTANT: The top deck MUST
be centered on the rear of the vehicle
for the windows to fit properly.
When tightening the rear straps notice
the location of the rear bar sewn into
the pocket on the top deck. It needs to
be centered on the rear roll bar legs.
Once the rear straps are secure (but not
tightened all the way), go inside the Jeep
and make sure the center bow flap is
wrapped round and secured to the center
bow. Also double check to make sure the
safety strap shown in Fig 21A is looped
around the center bow (FIGs 32 & 33).
FIG28
FIG29
FIG30
FIG31
FIG32
FIG33
Q_TJ_ADV_11113.00XX_LTR_BU.qxp_QTOP 6/16/20 12:11 PM Page 8