3
The Trusted Source
®
Put on safety glasses. Open the driver or
passenger door of your Jeep. Locate the
seat slider. (driver side shown)
(FIG1)
Snap the light bracket to the seat slider
as shown. Slide the front bracket as
close to the front of the seat as possible.
(FIG 2)
FIG 1
FIG 2
Installation Instructions:
Locate the 2nd bracket far enough back
to accommodate your flashlight. (FIG 3)
Using a 3mm Hex Allen Key install one
M5 x 45mm Screw and Flat Washer in
each bracket. (FIG 4)
FIG 3
FIG 4
Tighten the M5 x 45mm Screw until the
bracket is snug being careful not to over
tighten and damage the bracket. (FIG 5)
Snap -in flashlight and check fit. (FIG 6)
FIG 5
FIG 6
